Maintenance Programs

The Beckwith Maintenance Program is really an investment in your home that will pay off in less aggravation, lower repair costs and increased dependability. Heating and cooling equipment require on-going maintenance to retain efficiency, improve air quality and extend the life of your HVAC investment. Our maintenance program covers 21 critical areas of your heating and cooling equipment.

21 Point Heating Inspection:

  1. Check initial operation
  2. Check flue draft
  3. Check filter and belt
  4. Oil motors
  5. Check motor amps
  6. Clean and inspect burners
  7. Check pilot assembly
  8. Clean flame sensors
  9. Check pilot safety circuit
  10. Check flames for proper burn
  11. Check temperature rise
  12. Check fan control
  13. Check safety limit control
  14. Visually inspect heat exchanger
  15. Check carbon monoxide levels
  16. Check for rust and corrosion
  17. Check on proper vent operation
  18. Check any vent damper function
  19. Check and level thermostat
  20. Check thermostat amps
  21. Check thermostat operation


21 Point Cooling Inspection:

  1. Check initial operation
  2. Check filter
  3. Oil motor and lube bearings
  4. Check belts
  5. Check blower motor amps
  6. Check pulleys, wear & alignment
  7. Check blower wheel
  8. Check electrical connections
  9. Check condenser fan motor amps
  10. Check contacts
  11. Check wires and fuses
  12. Check crankcase heater
  13. Check for oil/refrigerant leaks
  14. Check fan motor and oil
  15. Check fan blade and rain shield
  16. Check and clean condenser coil
  17. Check systems pressures
  18. Check temperature drop over coil
  19. Check amp draw on compressor
  20. Check and level thermostat
  21. Check thermostat operation